01 · Symptoms
Does this sound like yours?
- A rattle or a thumping sound as it runs
- A high-pitched whine or whistle
- A grinding or squealing sound
- It’s much louder than it used to be
- The noise changes when you lift it off the floor
02 · Likely causes
What’s usually behind it
Something caught in the brush roll
A coin, a stone or a toy part can bang around the roll. Hair packed tight on the ends can also squeal.
A blocked or split airway
A whistle or whine is often air squeezing through a gap or past a blockage in the hose, wand or nozzle.
A loose part or cover
A bin, filter or cover that isn’t clicked in properly can rattle against the body.
A tangled or worn roll
A roll with flattened bristles or packed hair runs rough and loud. On many Ryobi models, a tangled brush roll is a common cause of trouble. Ryobi roller notes
Worn bearings
A grinding or screaming sound that gets worse is often the motor bearings giving out. Left running, they can overheat.
A failing motor or fan
A loud whine that rises and falls, or a rattle from deep inside, can mean a damaged fan or a motor on its way out.
03 · Safe checks
What you can check yourself
Switch off and unplug before you check anything
For cordless models, take the battery out first if your manual shows how. Never use a battery that is swollen, damaged or very hot.
- Switch off and unplug.
Then listen again with the vacuum lifted off the floor, to tell a floor-head noise from a motor noise. - Check the roll.
Cut away hair and fibres, and take out anything stuck around it. - Look for a blockage.
Check the hose, wand and nozzle for something caught in the airway. - Check the filters and bin.
Empty the bin and clean the filters as your manual says. - Refit everything firmly.
Click the bin, filters and covers in until they sit flush. - Test it.
Run it for a short time and note what the noise sounds like and when it happens.
04 · When to call us
Call now if any of these are true
- A grinding, screaming or squealing sound that doesn’t go away
- A noise from deep inside the motor, not the floor head
- It smells of burning, or you see smoke or sparks. Switch off, unplug if it’s safe, and call us
- It’s still louder than it should be after the checks above
- Try to describe the sound when you ring us. It helps us work out what’s wrong
FAQ
Is a loud vacuum dangerous?
Not always. A rattle from a loose cover is harmless. Grinding or squealing from the motor is a warning, so stop using it and call us.
Why does it whistle?
Usually a leak or a partial blockage in the airway. Check the hose and filters first.
Is it worth fixing a noisy vacuum?
Often yes, if it’s a bearing or a roll. On a very old or budget model, it depends on the fault. If it isn’t worth fixing, we’ll tell you.