01 · Symptoms
Does this sound like yours?
- The app says a wheel is stuck, suspended or has a problem
- It drives in a curve, or pulls to one side
- It spins on the spot, or only goes in circles
- It stops after a few seconds with a wheel warning
- A wheel makes a grinding or clicking noise
02 · Likely causes
What’s usually behind it
Hair wrapped around the axle
Long hair and thread work their way into the gap around each wheel and wind tight. That drags on the wheel, and the robot reads it as a fault. It’s one of the most common reasons for a wheel error.
Dirt or grit in the wheel well
Sand, fine grit and pet fur can jam the suspension spring and stop the wheel from dropping or rising smoothly. On many Roborock models, error 7 is a wheel-suspended warning. Roborock wheel tips
Climbing on something it can’t clear
A thick rug edge, a cable or a high threshold can lift one wheel off the floor, so the robot thinks the wheel is hanging.
A wheel that is worn
Tyre rubber wears smooth over time, particularly on tiled or timber floors. A wheel with no grip can slip and trigger the same fault.
A wheel motor or gearbox on its way out
Inside each wheel module is a small motor and gears. If hair has been dragging on them for a while, they can burn out or strip. A grinding or clicking noise points this way.
A control board fault
If the wheels are clear and free and the error stays, the fault may be in the electronics that drive them.
03 · Safe checks
What you can check yourself
- Switch the robot off.
Turn it over onto a soft towel. - Spin each wheel by hand.
It should turn freely. If it grinds or catches, you’ve found the area to look at. - Look for hair.
Pull out any hair, thread or fluff from around the axle and wheel well. Cut it with small scissors if it’s wound tight. Take care not to scratch the plastic. - Press each wheel in.
It should drop down on its spring and come back up smoothly. If it sticks, clear the grit with a dry brush. - Wipe the area.
Use a dry cloth around the wheel wells. No liquid. - Test on a plain floor.
Start a short clean away from rugs and thresholds.
04 · When to call us
Call now if any of these are true
- A wheel won’t spin freely after you’ve cleared it
- It grinds, clicks or squeals when the wheels turn
- It pulls to one side on every run
- One wheel stays down or up
- You don’t want to risk it. Call us and we’ll tell you what to do next
FAQ
Why does it keep happening?
If you have long hair or pets, hair builds up in the wheels again over time. A quick check once a month helps.
Can I swap a wheel myself?
Wheel modules are small, sealed and fiddly. Unless your manual shows you how, leave it to a technician.
Is it worth repairing?
Often it is, when the cause is a worn wheel. We’ll check it and tell you plainly if it isn’t.