01 · Symptoms
Does this sound like yours?
- A hiss or whistle from a wall inlet while the unit is running
- An inlet door that hangs open, sticks or won’t spring shut
- A cracked, loose or wobbly faceplate
- Suction that has dropped everywhere, not just at that inlet
- The hose feels loose in the inlet, or won’t stay in
02 · Likely causes
What’s usually behind it
Dirt or hair stopping the door closing
A bit of grit or a wisp of hair caught in the hinge or the seal is enough to hold the door open a fraction. It’s a small gap, but the whole system is pulling air through it.
A seal that has worn out
The rubber seal around the inlet hardens and cracks with age. A seal that no longer grips lets air leak in even when the door is shut.
A broken hinge or spring
Hinges are plastic and springs fatigue. When either one fails, the door won’t close properly or hangs loose. Replacing the inlet is a technician job, because the control wiring is behind it.
Loose screws or a cracked faceplate
A faceplate that has worked loose lets air leak around its edge. Sometimes the plastic itself has cracked from a knock.
Broken contact pins
If the inlet door closes but the unit won’t start from it, the pins may have snapped or come away. If that sounds familiar, see why some inlets stop working.
A leak behind the wall
A loose joint in the pipe behind the inlet can sound the same as a faulty door. The hiss is there even with a perfect-looking inlet.
03 · Safe checks
What you can check yourself
Don’t open the power unit
It runs on 240V mains power. The checks below are done at the inlet only, with the unit switched off, and never involve taking the wall plate off.
- Switch off at the wall.
Turn the power unit off at its socket first. - Find the right inlet.
Switch the unit on with every door shut and listen at each inlet, then switch it off again at the wall before you touch anything. - Open and close the door.
It should spring shut firmly. If it drags, look for grit or hair in the hinge and clear it with a dry cloth. - Wipe the seal.
Clean the rubber seal and the edge it sits against. - Tighten loose screws gently.
If the faceplate wobbles, tighten the screws by hand until they’re snug. Don’t force them, and stop if the plastic starts to crack. - Check the hose fit.
Plug the hose in. It should sit firmly. A loose hose cuff can leak too.
04 · When to call us
Call now if any of these are true
- The hiss is still there after cleaning and a firm shut
- The door, hinge or spring is broken
- The faceplate is cracked, or the screws spin without tightening
- The seal is cracked, flat or missing
- You can’t tell which inlet is hissing. Call us and we’ll talk it through
FAQ
How much suction can one leaking inlet steal?
It varies. Air takes the easiest path, so a leak anywhere on the system pulls from the rest. Even a small hiss is worth fixing, and you’ll often notice the difference when it’s sorted.
Can I tape over it?
We wouldn’t. Tape peels, and it can hide a fault that’s getting worse. A proper seal or inlet replacement is a better fix.
Does a broken inlet mean the pipes are damaged?
Usually not. The inlet is a fitting at the end of the pipe, and it’s designed to be swapped out. The pipes in your walls rarely need to change.